Chimney is one of the facilities essential to the process of boiler structures, primarily as hot flue gases or smoke emissions from the boiler to provide ventilation effect. Typically in the production of chimneys, choose as a vertical structure, in order to ensure smooth flow of the gas, the intake air into the combustion or the so-called chimney stack effect.
Mill 10 tons of 35 tons steam boiler price? Some large textile mill boilers are basically used in more than 10 tons, not only production, but also to use the heating plant, which accounted for up you are relatively complicated, than a single price, then the price is way boiler the more expensive. After recently, I received a large textile mill issue price of 10 tons consulting steam boiler, pre-sales engineer fast Boiler accounting, now the mill with steam boiler of 10 tons is required to meet the production and operation of life. For the price of this type of boiler, auxiliary equipment currently includes around 100 million. Accounting specific price needs to be accounted for after reading the customer site.
Comfortable life of people is inseparable from the northern winter heating boiler, normal, stable heat source is vital to people's lives. But the attendant is an increasingly serious environmental pollution problems, the implementation of coal to gas policy without delay, using the gas hot water boiler is the general trend. In order to achieve green heating, the National Tourism Administration Service Center decided to phase out the existing coal-fired boilers, the introduction of clean and environmentally friendly gas hot water boiler. Fast boiler with their own strong comprehensive strength and rich experience in the heating industry cooperation gained the trust of the National Tourism Administration Service Center, and ultimately provide a vacuum hot water boiler (T6-2800 2 sets of 2.8MW by fast Boiler ).
Condensing steam boiler can be favored by many enterprises because of its energy-saving, environmental protection and tolerance, and has gradually become one of the most popular boiler products in boiler products. The heat-resistant and wear-resistant condensing steam boiler needs to produce a large amount of steam through water, so it is necessary to inject a large amount of water into the equipment during operation. Because the equipment requires strict operation of boiler water filling, it needs to be operated according to the standard before it can be used normally. The condensing steam boiler equipment should pay attention to when feeding water to the equipment and see the following brief description:
1: in order to prolong the service life of the boiler, the condensing steam boiler reduces the occurrence of precipitation in the furnace in order to prolong the service life of the equipment and reduce the occurrence of precipitation in the furnace due to the different properties of the different water quality and the different precipitated substances. Therefore, the use of water quality has certain requirements and can choose the applicable water quality, which can improve the service life of boilers and reduce the production of a large amount of water scale. There are certain requirements for the use of water is not any kind of water can be used, in order to effectively protect the service life of boilers should pay attention to the selection of water suitable for the water quality requirements. And the water used must be soft water that has been tested and treated so that it does not produce a large amount of water. The long-term accumulation of dirt in the boiler causes pollution to affect the quality of use.
2: there are relevant standards for water temperature control during the operation of condensing steam boilers. Users should pay attention to controlling the water temperature within the standard range in order to achieve good use without anomalies. If the water temperature is too high, the high expansion of the whole equipment will cause the pipe to leak, and the low water temperature will make the steam production not enough to meet the normal use requirements of the enterprise.
3: when adding water to a condensing steam boiler at the standard level, attention should also be paid to the standard water level, which should not exceed the height of the water mark in order to ensure safety in use. Higher than the water level will not only cause waste but also cause the equipment to expand. When the expansion reaches the limit of the water level, it will cause the water to spill out and waste or even shorten the service life of the equipment.Free Chat
Copyright © 2020.Company name All rights reserved.