? First: to improve fuel will be coal into gas in principle, more in line with the standard requirements of the relevant countries, fueled by coal imported large boiler brand has been subject to strict national authorities to stop, that there is often a boiler in the enterprise will fired boiler into gas boiler rehabilitation programs embodiments, may use natural gas or alcohol as a fuel after passing through this transformation, the raw coal to reduce all kinds of pollution caused by the fuel, thus using not only environmentally friendly but also improvement in the fuel cost. Second: the furnace to improve coal-fired boiler furnace into a gas furnace is the use of coal-fired auxiliary boiler for heating the furnace, and then to improve the use of gas for heating, if not exactly when or poor fuel atomization in the combustion gas gathering hearth or tail, it is very prone to catch fire or explode, so then you need to hearth to improve device blast doors, while adding automation and control ignition and flame failure protection devices to ensure safe operation of the furnace process. Third: When ancillary equipment prior to improvement has not improved during the coal-fired furnace operation requires a lot of ancillary equipment to carry out normal operations, ancillary equipment commonly used in general including the coal, Cleaner, dust collector and grate, etc. followed by boiler using these accessory devices do not need to use a gas stove, so you can save and invest more of boiler equipment. Fourth: to improve the degree of environmental protection we all know has been a coal-fired furnace is not allowed by the national environmental policy, coal is a serious source of pollution not only pollutes the environment but also cause a variety of effects on the body, adopted after performing boiler gas furnace and greatly reduce emissions of soot and various dust can effectively improve air quality, more environmentally better protect the cleanliness of the air, but also more in line with national standards of environment protection and energy policy.
The difference between oil-fired imported large boiler brand and gas boiler difference between oil-fired boiler fuel oil boiler and gas boiler is fuel (such as diesel, oil, kerosene, etc.), fuel gas-fired boiler to gas (such as natural gas, city gas, methane, etc.), depending on the boiler What fuel burning device called a burner, gas burner configuration called boiler gas boiler, oil boiler burner configuration called oil-fired boiler, oil-fired boiler and gas boiler difference lies in the use of fuel burners burn anything.
Factors which influence energy-intensive industrial imported large boiler brand energy-intensive industrial boilers factors influencing factors which have high energy consumption of industrial boilers which have 1, energy consumption is low management level industrial boiler is too large, are long-term presence of many companies in the current . On the one hand understanding of the enterprise energy conservation boiler is still not sufficient, on the other hand the energy management level is still at a low level, and even some companies even the most basic measuring instruments are not equipped. In order to reduce operating costs, many companies have to buy the old boiler use, lack of components purchased fuel means of inspection. Even in the case of raw coal screening is not performed, it is directly put into production use, it is difficult to ensure full combustion of coal. Not only the thermal efficiency is low, but also resulted in a waste of fuel. 2, heat recovery is poor combustion is incomplete, the situation is the high rate of heat loss is extremely common in industrial boilers used in the process, saving the main parameters of the boiler will be exceeded. Economizer function is to heat energy recovered, but in actual use, heat recovery efficiency is very low. In this case, do not use a lot of boiler economizer direct altogether, inevitably produce exhaust gas temperature is too high. Meanwhile, return the device and steam condensate recovery, it has not been fully appreciated and better use, some are put to use in the boiler after installation, and did not take appropriate measures to deal with poor recycling effect. 3, lack of effective supervision of the level of energy service work, depends largely on the level of experience and technical personnel. But in practical terms, due to the lack of technical personnel, resulting in the energy service work at the level of the low. Various enterprises produced energy-saving products with high imitation, coupled with the lack of effective supervision of energy-saving measures, resulting in the entire market of energy-saving products more confusing. The effect of not only energy-saving effect is not ideal, and to transform the poor, the performance of energy-saving products remains to be greatly improved. Market confusion, vicious competition phenomenon has not been fundamentally curbed.
It is reported that fast imported large boiler brand opportunity to help APEC summit, with more than Institute, universities collaborate to jointly develop the latest ultra-low nitrogen oxide emissions control technology, nitrogen oxide emissions will be maintained at 33 mg / m within the scope of the emissions has exceeded European standards in the future, this technology will better serve the Beijing as well as the national gas boiler renovation project. "Our vision is to: continue to meet the energy needs of user convenience and energy saving, the fast boiler build the first brand of Chinese clean boiler future we will continue in different areas of ultra-low nitrogen, ultra-low dust, low noise, etc. continue to explore. in order to achieve greater results. "the technician said in conclusion.Free Chat
Copyright © 2020.Company name All rights reserved.