The higher the air pressure of the steam boiler, the higher the energy consumption, and the corresponding pressure on the steam equipment and the piping and valves will also increase, which will make the maintenance of the steam boiler relatively advanced. The share of steam that is dissipated and lost during the occurrence and delivery process will also increase. The salt contained in the high-pressure steam will increase with the increase of the air pressure. These salts will cause the structural appearance of the heated area such as the water wall tube, the smoke pipe and the drum, causing overheating, foaming, blockage, etc., and causing the pipe to blast when severe. Risky incidents.
1. Pay attention to the amount of fuel. Avoid more fuel in the boiler. If there is too much fuel in the furnace, the fuel will not be fully incinerated, and some incinerations that have not been completely incinerated will occur. If the furnace is found to be dark, the fire is small, and the chimney is emerging. Conditions such as black smoke are usually caused by carbon monoxide in the furnace.
2. The size of the incineration material used. From the point of view of incineration, the smaller the volume of fuel, the simpler it is to mix with air and simply incinerate. However, if the volume is too small, the energy consumption will increase greatly with respect to the gas-fired steam boiler, and the exhaust gas will increase, which will also cause the loss of fuel to a certain extent.
Commercial gas hot water low pollution boilers for package plant side fast compared to traditional boilers, whether in design or structural form is a kind of new breakthrough, the boiler in environmental protection, energy, security, automation, service life, installation, power consumption, capacity terms of expansion, and covers an area of space has unparalleled advantages in all types of new construction, renovation heating, hot water project has been widely used.
The causes of low pollution boilers for package plant scale boiler water as a medium for heat exchange apparatus A specialty. During operation the surface of furnace and boiler water contact form thick layer of scale, over the years, people have dirt kinds of boiler scale due to the scale have been fully studied, introduced a variety of anti-scaling technology, but still not been completely resolved, while the development of antifouling cleaning technology, as an adjunct to maintain heating surface and the heat transfer surface. So, boiler scale is how did this happen? There are three main reasons: First, the boiler feed water impurities into the boiler, through continuous evaporation and condensation, boiler feed water, concentration of salts continuously increases, the degree of saturation or supersaturation, will be in the boiler metallic surface the precipitated precipitate. Second, with the increase of the boiler water temperature, the solubility of certain salts and inversely proportional to temperature, these salts at elevated temperatures, the solubility is drastically lowered opening formed scale. Third, the interaction of different salts or thermal decomposition to produce a compound difficult to dissolve. Boiler feed water in a continuous process of continuous evaporation, the pure water into steam by the boiler feeding the salt water continuous furnace substance was concentrated, the content of rising. When the boiler feedwater salinity level of saturation or over-saturation, salt materials will precipitate from the water, form a solid precipitate. Adhering a larger portion of their thermal load heating surface to form a hard or soft scale, another portion of the furnace was suspended in water with the boiler water circulating flows. When the heat receiving face of the poor circulation, the flow rate is low, then the deposition of scale on the heating surface to form a secondary, or deposited on the drum should not have high flow rates, a lower collection tank, dirt is formed, with the periodic sewage discharge from the furnace. Thus, generation of scale, in addition to the ingredients and contents of impurities in the boiler water related, but also to a large extent depends on the operating state of the boiler. The larger the water evaporation intensity, the higher circulation rate, the easier it is to generate water circulation easily broken loose precipitate, evaporation of the boiler assembly can reduce the number of scale on a surface. In contrast, evaporation intensity, the lower the cycle rate, the more easy to form scale on the surface of the evaporation boiler.
On January regular press conference, Secretary, Ministry of Environment environment atmosphere Liu Bingjiang said: Through the joint efforts of the whole society, national ambient air quality is generally improving. But issues of current emissions of air pollutants is still high, industry structure, energy structure is still prominent, air pollution control remains to be done.
2019 is to win the battle of the blue sky in tackling it. China Environmental Science Research Institute Professor Xue Zhigang said China is still partial to change the energy mix of coal to Beijing and Tianjin, for example, though not local, but coal consumption per unit area of 5 to 6 times the national, so to adhere to focus total coal consumption areas under control.
First, the structure of coal-based energy, coal pollution characteristics significantly. Shaanxi, Shanxi coal-producing province is also the province's coal consumption, coal consumption Fenwei plain more focused, coal accounted for nearly 90% of energy consumption, much higher than the national average of 60%.
Second, the emphasis on regional industrial structure, industrial pollution emissions from large. Fenwei plain alumina, coke, iron and steel, coal, chemical and other heavy chemical industry, small-scale enterprises, low level of equipment, and most enterprises have yet to achieve a stable discharge standards, ultra-low emission completion percentage less than the transformation of thermal power enterprises in Beijing, Tianjin the level of pollution control needs to be improved.
Third, the prominent road transport pollution, emissions from large heavy vehicles. Fenwei plain is an important channel Shaanxi, Inner Mongolia and Shanxi coal Sinotrans, common to road transport, heavy industry-oriented industrial structure to further increase the pressure of road transport.
Hebei Province in 2019 government work report, determined to win the battle of the blue sky, ultra-low emissions to accelerate the transformation of key industries and promote clean coal casual alternative, "scattered dirt" dynamic business continuity cleared, Hebei Province, the year will be 10 million tons of coal Yajian thermal power 500,000 kilowatts.
Tianjin in 2019 to promote low-nitrogen transformation and construction work clean diesel transformation of mechanical gas-fired boilers, in an orderly urban and rural residents clean alternative to coal for heating, PM2.5年均浓度持续下降. In addition, Guizhou, Gansu, Heilongjiang and other places have made the coal control target.
It is reported that, after the heating season this year, the Ministry of Environment will work with ecological scientific and reasonable arrangements around 2019 bulk coal management plan. Regional authorities will further strengthen joint prevention and control, continue to implement the autumn and winter tackling action in key areas. In the future, China will focus on promoting the Beijing and Tianjin and the surrounding areas, as well as bulk coal governance Fenwei plains, to the 2020 heating season, the basic completion of the plains to live and bulk coal for heating in winter instead.Free Chat
Copyright © 2020.Company name All rights reserved.