Hot water boiler which is not equipped with no impact can cause demineralizer 1, the waste fuel boiler fouling occurs, resulting in poor heat transfer performance of heating surface, so that heat generated by the combustion of the fuel can not be timely delivered to the boiler water, but a large amount of heat is smoke away, resulting in exhaust gas temperature is too high, if the exhaust gas loss increases the thermal efficiency of the boiler will be reduced. In order to maintain the nominal parameters of the boiler, fuel must be increased, thereby wasting fuel. About 1 millimeter scale waste fuel ten percent. 2, the heat receiving surface is damaged due to deterioration of the heat transfer performance, fuel combustion heat is not quickly transmitted to the boiler water, resulting in the furnace and the flue gas temperature. Thus, the temperature difference on both sides of the heating surface increases, the metal wall temperature, a decrease in strength. Under pressure pot, bags and even blasting will occur. 3. Reduce heat boiler output due to the deterioration of the performance of boilers, need to consume more fuel to reach the nominal rate of evaporation. However, with the increase in the scale thickness, the volume of the furnace becomes large, the fuel consumption is limited. Therefore, it is possible to reduce the output of the boiler. 4, the corrosion damage to the metal: oxygen in the water, acid, base materials will corrode the metal surface of the boiler, it is thinned, recess or perforation, thus reducing the power of the boiler, seriously affect the safe operation of the boiler. 5, in addition to improper operation Priming outside, when the boiler water contains more sodium chloride, sodium phosphate, and silicides oil, boiling or evaporation process boiler water, boiler water occurs when soap and organic base when Teng because soda will produce compost. Foam liquid surface, formed soda pool. No softening, easily scalable. Due to the continuous evaporation steam, boiler of calcium, magnesium, high impurity concentration is 30-50 times that of natural water, fouling rate beyond our imagination, only six months to a year, from 1-2 mm.
Battle to win the blue sky, is the major decisions and plans to make a big party in the nineteenth, and is for building a moderately prosperous society, to improve the quality of life of citizens and establish a beautiful China's development goals. To fully implement the nineteen spirit, promote the governance of air pollution intensity and improve the living quality of the environment, this year March 8, Zhengzhou Municipal Party Committee General Office, Zhengzhou Municipal People's Government Office issued the 2018 air pollution control program and the corresponding subsidy policy, the implementation of low-nitrogen gas boiler retrofit demonstration project, as follows:
Before the end of September 2018, the city's more than 20 tons of steam (with), and the urban areas more than 4 tons of steam (with) the completion of gas-fired low-nitrogen transformation project demonstration projects, nitrogen oxides emission concentration is not higher than 30 mg / cubic meter, City level financial awards complement carried out in accordance with the 40% investment in equipment;
Before the end of September 2018, the city's more than 4 tons of steam (with), and the urban areas more than 2 tons of steam (including) low nitrogen gas boiler reconstruction project completed demonstration projects, nitrogen oxides emission concentration is not higher than 30 mg / cubic meter, City level financial awards complement carried out according to 30% of equipment investment;
Before the end of April 2019, the city completed all gas-fired low-nitrogen transformation, nitrogen oxides emission concentration is not higher than 30 mg / cubic meter, the municipal finances awards complement of 15% investment in equipment.
Fire boiler design pitch is much: a room, boiler production plant belongs to class D, to a plc control steam boiler rated evaporation 4t / h, when the rated output is greater than 2.8MW hot water boiler, the boiler room building fire resistance rating of not less than two ; rated evaporation steam boiler is less than or equal to 4t / h, when the hot water boiler is equal to or less than the rated output 2.8MW, between the boiler building fire resistance rating of not less than three; m-inter-tank, oil pump and the oil heater are inter production plant belonging to class C, not less than two of its construction fire rating, between said room is arranged within the auxiliary boiler room, a room should be set apart from other firewall; March and gas regulator production plant belonging to Group A, which building fire rating of not less than two, should be provided between the boiler room and the immediate neighborhood regulator firewall spaced boiler room, which doors should open outwards and should not directly access to the boiler room, the ground should not be spark Ping.
The main structure of a natural gas boiler consists of a boiler shell, a tank, a switching chamber, a smoke pipe, etc. The boiler is suitable for various fuels such as light oil, heavy oil, natural gas, liquefied gas, and so on. The boiler has a reasonable structure and a double-layer reverse burning. It is beneficial to make full use of flue gas, and has the characteristics of small area, convenient installation and good steam quality. The working principle of natural gas boiler is: the water enters the boiler through the inlet, the water quality that meets the heating standard after the boiler is heated, the water is fed into the indoor radiator through the circulating pump, the heating is heated by radiation and convective heat transfer, and the water flowing through the radiator is flowing through the water of the radiator. Go back to the boiler and heat it up, and then go back to it. It flows into the radiator, so that it circulates over and over again. Moreover, the natural gas boiler system can also provide users with hot water to meet its basic needs, the temperature of the water quality in the boiler and the indoor temperature, after temperature sensor processing, the temperature signal is transmitted to the single-chip microcomputer. Through the corresponding driving circuit, to adjust the size of the corresponding pipe valve, and then by controlling the water quantity to control the water temperature, to achieve the purpose of heating, the user can also select the appropriate circulation pump according to the size of the heating range. This is also more economical and convenient.Free Chat
Copyright © 2020.Company name All rights reserved.